A range of Specialist Clamping Magnets including supermarket ceiling magnets for suspended promotional signs, car roof top clamping magnets and a range of work holding magnetics which can be used for an infinite variety of holding and temporary holding applications including welding, machining and measuring.
White plastic capped ceiling magnets,40mm in diameter and are designed to clamp to the metal strips in suspended ceilings and onto steel panels in supermarket ceilings.
They have a 4kg maximum pull and a hook to accept wire hangers or string to promotional signs and displays
The car roof top magnet is designed for applications where high shear strength is required with minimum scratching. The car roof magnet is a magnetic clamping assembly with a soft polyurethane coating. The soft polyurethane coating causes almost zero abrasion but gives a much higher surface friction. Most magnets have a strong direct pull force but they can be made to slide along a surface with about 20% of the direct pull force when used on steel. The car roof top magnet has a strong direct pull force but the increased friction of the polyurethane means that it takes around twice the direct pull force to get the magnet to slide. This means that the car roof top magnet resists sliding along a ferromagnetic steel surface better than magnets without the polyurethane coating. It can provide immense resistance to shear forces when mounted on a smooth metal surface, as typically found on motor vehicle body parts.
Fixed 90 degree welding clamps hold 2 pieces of steel securley at 90 degrees so that they can be welded together.
Varable angle welding clamps hold 2 pieces of steel securley at any angle between 45 and 90 degrees so that they can be welded together.
Fixed multi angle welding clamp holds 2 pieces of steel securley at 30, 45, 60, 75, 90 or 180 degrees so that they can be welded together.
Adjustable angle weld clamps hold 2 pieces of steel securley at any angle so that they can be welded together. Please note that this MAG920 has four circular steel keeper plates that need removing before use to allow it to clamp fully to steels.
This small and easy to operate hand magnet exerts a powerful pull of up to 30kgs on a flat steel surface and the magnetic attraction is released by simply squeezing the release trigger.
The footprint of the magnet is 90mm x 50mm.
It is ideal for lifting out steel parts from moulds or laser cut parts out of the original sheet.
Switchable magnets allow flexibility in the positioning. They can be used to mount a component to the desired position.The magnet can then be switched on to hold the component in place either permanently or temporary by exerting upto 60kgs of magnetic holding force and can be switched off when required.The magnet has toggle switch on the end which is ideal for a quick release.
Each unit has an M8 threaded hole in the top for convenient mounting.
